ST Link V2 Programmer For STM8 and STM32

Supports For ST-LINK V2 :

1. ST-LINK Utility 2.0 and above.
2. STVD 4.2.1 and above.
3. STVP 3.2.3 and above.
4. IAR EWARM V6.20 and above.
5. IAR EWSTM8 V1.30 and above.
6. KEIL RVMDK V4.21 and above.

Features :

1. PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
2. Interface definition directly marked on the shell, clear, convenient and practical!
3. 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
4. Shell characters using laser engraving, never fade off! Permanent clarity!
5. 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
6. Red and blue color LED indicator, allowing you to always observe ST-LINK V2 working condition!
7. With 4 DuPont line, so you can easily respond to different target board line order!
8. Use anti-static bag packaging.

9. SWIM specific features:

   • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
   • 1.65 V to 5.5 V application voltage supported on SWIM interface
   • SWIM low-speed and high-speed modes supported
   • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
   • SWIM cable for connection to the application
10. Direct firmware update feature supported (DFU)
11. Status LED which blinks during communication with the PC
12. Operating temperature 0 to 50°C

Package Includes:

1 x ST-Link V2 Programmer For STM8 and STM32.

1 x Connecting Wires.